belfox Premium Slider 500 Bedienungsanleitung Seite 58

1 1 9 9 . . C C o o n n n n e e c c t t i i o o n n s s ( ( c c o o n n t t r r o o l l u u n n i i t t 4 4 7 7 - - 2 2 1 1 - - 0 0 o o r r o o p p t t i i o o n n a a l l l l y y 4 4 7 7 - - 2 2 1 1 - - i i ) )
Fatal electric shock from mains voltage!
There is a risk of life-threatening / fatal electric shock on contact with the
mains voltage.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
x Electrical connections may only be carried out by a qualified electrician.
x Installation, adjustment and maintenance may only be carried out by
qualified personnel!
x Switch off the voltage before carrying out work on the drive!
x Reliable operation only with careful assembly according to these instruc-
tions!
x Only switch off the voltage after a further, careful
x Control back on. Note the polarity
x
Never apply 230V to terminals 7 or 8! This will immediately destroy the
control unit and void the warranty!
Damage to the controller due to moisture / dirt
Penetrating moisture, dust or dirt can permanently damage or destroy the
controller.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
Protect the controller from moisture, dirt and direct sunlight when opening
the controller housing.
(Attention: Changes may occur here. Please note the attached instructions for
the engine control unit)
Of course, you can connect additional devices to the control system according
to your wishes. (However, only use BELFOX products. Errors can occur with
third-party products and destroy the motor control unit. The warranty is void if
third-party products are used). The individual functions of the connections can
be found in the enclosed control instructions 47-21-0 (optional control instruc-
tions 47-21-i)
DANGER
NOTE
24