Herunterladen Inhalt Inhalt Diese Seite drucken

Replacement Parts - Koala Kare KB310-SSRE Bedienungsanleitung

Babywickelstation
Vorschau ausblenden Andere Handbücher für KB310-SSRE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

KB310-SSRE
Operations Instructions
Please Note
To assure proper installation, it is suggested that
a qualified person or carpenter install the Koala
Baby Changing Station. Koala Kare Products will
not be responsible if the station is not installed
properly. Koala Baby Changing Stations have
been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is
capable of holding a substantial load. The maximum
recommended total weight for this baby changing
station is 11 kg. Excessive weight may cause a
hazardous or unstable condition to exist.
Inspection Criteria
A properly maintained baby changing station:
• Opens and closes smoothly.
• Has a functioning strap and buckle. Strap is held
firmly in place when buckle is depressed over it.
• Offers parents liners through a fully stocked liner
dispenser. (Dispenser built into unit.)
• Provides a clean, convenient place for customers
to attend to their children.
Restraint System
Check strap by releasing the lever on the buckle and
pulling one end of the strap up through the bottom
of the buckle, depressing the lever when the strap is
tight. Give the strap a tug in the horizontal direction
away from the buckle, checking that the strap
remains in place beneath the buckle. To loosen the
strap, release the lever and pull the strap from the
bottom of the buckle.
EN 12221:2008+A1:2013
WARNING: Do not leave child unattended.
All assembly fittings shall always be correctly
tightened and checked regularly.
Be aware of the risk of open fire and other sources
of strong heat, such as electric bar fires, gas fires,
etc. in the near vicinity of the changing unit.
Do not leave the child unattended. The changing
unit is intended for infants age up to 12 months,
with a maximum weight of 11 kg. Do not use
changing unit if any parts are broken or missing.
A changing pad is not required for this product.
Additional or replacement parts shall only be
obtained from the manufacturer or distributor.
Unit should be cleaned once or more daily with a
clean nylon brush and spray disinfectant.

Replacement Parts

For a list of replacement parts for this product,
(such as straps, shocks and labels) please visit
www.koalabear.com.
Replacement parts and additional liners can be
purchased from your local distributor or direct from
Koala at www.koalabear.com.
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis