Initial Start; Operating Modes - clearaudio electronic Professional Power 24V Bedienungsanleitung

User manual / Bedienungsanleitung

3. Initial start

Clearaudio has developed a special packaging for your
transportation.
Please keep this original packing, if you need to ship the unit.
Take the device out of the box and set it up at the desired location.
Before connecting the device to the power supply, make sure that the main switch on the back is
set to "0" (=OFF).
1. Connect the device to the mains with the enclosed power cord.
2. Then connect your turntable and the
instead of the standard plug-in power supply.
3. Now you can turn the main switch on the back to „I" (=ON).
4. The LED light on the front panel of the
seconds, while the device starts up and the output voltage stabilizes.
5. When the LED light shines continuously, the device is ready (ON mode) and you can start the
turntable.

4. Operating modes

4.1 Standby
The „Standby" mode is characterized by:
6. The output is deactivated (the turntable is not supplied with power).
7. The LED light is off.
4.2 ON
The „ON" mode is characterized by:
1. The output is activated (the turntable is supplied with power).
2. The LED light shines continuously.
4.3 Dimming the LED
The LED light on the front panel can be darkened or lightened by one level by long pressing the ON/
OFF/Standby button on the front panel.
Made in Germany
Professional Power 24V
Professional Power 24V
Professional Power 24V
to ensures a safe
with the built-in power cable
starts to flash for approx. 40
Page / Seite 5