Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Trouble-shooting:
Faults experienced
Solution/how to resolve the problem
Check it has been correctly connected.
Check that the USB port used (computer,
The meter isn't
mains adapter...) is receiving power.
Press the ON button.
Check the value set for the alarm (step
2).
Make sure the sound of the alarm has not
The alarm doesn't
been disabled. Enable the sound if
necessary by pressing the designated
button (step 3).
The alarm is only available for the
measurement of CO2.
Check that the USB and micro USB ports
are properly connected.
The battery isn't
Check that the USB port used (computer,
mains adapter...) is receiving power.
-55-
AIC International - 44980 Ste Luce sur Loire - France
Importé par :
Faults experienced
Solution/how to resolve the problem
Use the cable provided. The meter must
be properly switched on (ON position) to
be recognised.
The software does
Try the following two steps:
not recognise the
Turn on the meter and wait for it to warm
meter.
up. Connect the USB cable and start the
software.
Turn on the meter and wait for it to warm
up. Start the software. Then connect the
USB cable.
Go to step 6 to set the recording
The measure-
parameters.
ments aren't being
Follow step 7 properly to save the
recorded/saved.
recording.
Importé par :
AIC International - 44980 Ste Luce sur Loire - France
-56-
Werbung
