Safety Switches; Overheat Protection; Maintenance - Klarstein CHAVAL Bedienungsanleitung

EN

SAFETY SWITCHES

Overheat protection

This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids.
In this case, unplug the appliance, wait about 30 minutes for it to cool and remove the
object which is obstructing the grids. Then switch it back on as described above. The
appliance should operate normally. Should the problem persist, please contact the
nearest customer service.
Tip-over protection
This heater is protected with a safety switch that turns off the appliance automatically
when the heater falls over, or is at an excessive angle from the horizontal. This helps
prevent accidents, and the heater will back to the standby mode when it is put back
upright, press the buttons on control panel or remote control to reset the heater.

MAINTENANCE

When your heater needs cleaning, wipe exterior surfaces of the heater with a moistened
cloth. Not rinse with water directly. Be sure to unplug before cleaning.
Pull out filters and clean them, when it is very dirty.
To prolong the heater life, not disassemble it personally when malfunction occurs.
Send your heater to relative identification after-sold service center or provider for the
convenience inspecting.
16