Electrical Connection - HEC GS121S-PE Bedienungsanleitung

Installation
Positioning the appliance
Positioning the appliance in the desired location. The back should rest against
the wall behind it, and the sides, along the adjacent cabinets or wall. The dish-
washer is equipped with water supply and drain hoses that can be positioned to
the right or the left to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to
adjust the dishwasher, making it level. In any case, the appliance should not be
inclined more than 2˚. If the appliance is level, it will help ensure proper
performance.
Cold water connection
Connect the water supply hose to a threaded 3/4 connector, making sure that it
is fastened tightly in place (see fig.A). Some models are fitted with an "Aquastop"
water supply hose (see fig.B) in which the small filter is already housed in the
threaded end.
If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear and free of impurities.
If this precaution is not taken, there is a risk that the water inletcan get blocked
and damage the appliance.
fig.A
Warning
The appliance is to be connected to the water mains
using new hose-sets and that old hose-sets should
not be reused.
Anti-Flooding protection (for some models)
The dishwasher is equipped with a system that stops the supply of water in the event
of a problem with the water supply hose, or leaks within the unit, in order to prevent
damage to your home. If for any reason the box containing the electrical components
happens to get damaged, remove the plug for the appliance from the socket
immediately. In order to guarantee that the anti-flooding feature operates properly,
the "A" box with water supply hose must be attached to the water supply tap as
shown in fig.B. No other type of connection is acceptable.The water supply hose
must not, under any circumstances, be cut, as it contains electrical parts which are
live. If the length of the hose is not adequate to make a proper connection, the hose
must be replaced with one which is long enough. This hose is available upon request
from specialised retailers and service center.
2
All manuals and user guides at all-guides.com
fig.B
Drain hose connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. If necessary, fit a
syphon trap (U-bend) with a connecting piece for the drain hose (fig.C). The
free end of the hose must be at a height between 40 and 100 cm and must not
be immersed in water.
Attention:
The connecting piece for syphon trap (U-bend)
must be solidly fastened to the wall to prevent
the drain hose from moving and allowing water
to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for your home corre-
spond to those on the rating plate (located on the stainless steel inner door of
the appliance) and that the electrical system is correct for the maximum voltage
on the rating plate, insert the plug into an electrical socket which is earthed
properly (the earthing of the appliance is a safety requirement mandated by
law).
If the electrical socket to which the appliance must be connected is not appro-
priate for the plug, replace the whole cable, rather than using adaptors or the
like as they could cause overheating and burns.
Caution:
The dishwasher plug must be accessible even
when the appliance is installed as a built-in unit
so that maintenance can be done safely.
EN
fig.C