Palram SKYLIGHT Montageanleitung Seite 6

EN
Option #1:
Mounting the shelf in the
middle of the side wall
(Not suitable for 4x6 shed)
Attention:
• Do not mount more than 2 shelves onto one panel.
• Do not mount more than 4 shelves on a single wall.
• Under any circumstance do not mount more than 10 shelves per shed.
• A single shelf can carry up to 30 kg (66 lbs).
Option #2:
Mounting the shelf where the
shelf's left side connects with the
shed's corner
Option #3:
Mounting the shelf where the
shelf's right side connects with the
shed's corner
During Assembly
• Panel (#9633) is not pre-drilled; therefore you must drill the holes with
accordance to your chosen option.
• Metal plate (#8075) is used for mounting the shelf onto either one of the
shed's corners. If you did not choose this option, there is no need to use
this part; keep it for future use if needed.
• Tighten all screws when completing assembly.
Do not tighten screws and nuts (411 & 412) until completion of assembly process.
These 2 icons indicate if screws' tightening is required or not.
Option #4:
Mounting the shelf side by side
(only at the shed's rear wall)
(Not suitable for 4x6 shed)