Bahco TAW Serie Original Anleitungen Seite 28

TAW AND TAS SERIES
3. Use UP/DOWN buttons to select YES or NO selection.
4. Press ENTER button to accept selection and exit to Configure menu.
STD
Note: If Delete Presets is selected without a Preset configured, following screen is displayed:
torque and units then a target angle before
STD
e mode, when applied torque reaches target
measurement. Progress lights indicate applied
angle is measured. If torque is below target
ights will not turn on and if angle exceeds
ential problem with fastener.
CALIBRATION
Calibration menu is password protected. Refer to Calibration Manual.
et target torque and UNITS button to select
STD
to set target angle then press ENTER button.
o target angle.
SETTING DATE AND TIME
Set Date/Time function allows user to set real-time-clock date and time for time stamping data records,
recording last calibration date and notifying user of an expired calibration interval.
Note: When date and time is set for first time, In-Service date is also set and is used for calculating
initial calibration interval (see "Setting Calibration Interval" in Advanced Configuration section).
while on Torque THEN Angle screen.
1. From Configure menu, use UP/DOWN buttons to highlight SET DATE/TIME selection then press
th torque and angle reach targets.
ENTER button.
0% of tool full scale or if angle exceeds
2. SET DATE screen is displayed with year highlighted.
3. Use UP/DOWN buttons to set year then press ENTER button to highlight month.
sing and holding Units button while on
4. Use UP/DOWN buttons to set month then press ENTER button to highlight day.
s to full range plus 10%. Refer to "Adding
5. Use UP/DOWN buttons to set day then press ENTER button.
section for parameter entry.
6. SET TIME screen is displayed with hour highlighted.
7. Use UP/DOWN buttons to set hour then press ENTER button to highlight minutes.
8. Use UP/DOWN buttons to set minutes then press ENTER button to highlight seconds.
once.
9. Use UP/DOWN buttons to set seconds then press ENTER button.
ht DELETE PRESETS selection then
10. Clock is set and Configure menu is displayed.
figure menu.
SLIM/SCR
Note: If Delete Presets is selected without a Preset config
SLIM/SCR
SLIM/SCR
CALIBRATION
Calibration menu is password protected. Refer to Calibration M
SLIM/SCR
SLIM/SCR
SETTING DATE AND TIME
Set Date/Time function allows user to set real-time-clock date
recording last calibration date and notifying user of an expired
Note: When date and time is set for first time, In-Service da
initial calibration interval (see "Setting Calibration Interval
1. From Configure menu, use UP/DOWN buttons to highlig
ENTER button.
2. SET DATE screen is displayed with year highlighted.
3. Use UP/DOWN buttons to set year then press ENTER but
4. Use UP/DOWN buttons to set month then press ENTER b
5. Use UP/DOWN buttons to set day then press ENTER butt
6. SET TIME screen is displayed with hour highlighted.
7. Use UP/DOWN buttons to set hour then press ENTER but
8. Use UP/DOWN buttons to set minutes then press ENTER
9. Use UP/DOWN buttons to set seconds then press ENTER
10. Clock is set and Configure menu is displayed.
SLIM/SCR