Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LIGHT FUNCTIONS
1. Press the
button once to turn the unit ON. The Pool Light will colors flash randomly (default).
2. With the light switched on, you can press the
Show #1 – In-wave
Show #2 – Chasing
Show #3 – Steady
3. To switch OFF the light, press the
4. The built-in timer will start and reset automatically once the light is switched on. The default setting is 4 hours ON and
then 20 hours OFF.
CAUTION:
• Different types of batteries or new and old batteries are not to be mixed.
• Do not dispose of batteries into the fire. Batteries may explode or leak.
• Replace only with 4xAA 1.5V batteries.
• Remove the batteries if the Pool Light is to be left unused for a long time.
• The supply terminals are not to be short-circuited.
• Non-rechargeable batteries are not to be recharged.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries promptly and dispose of properly.
IMPORTANT
1. Do not submerse the Pool Light under water. It could damage the electronic components.
2. Make sure the battery cover is securely fastened before use.
3. Remove the Pool Light from the pool when not in use.
4. Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively support
us in conserving resources and protecting the environment by returning this appliance to the collection centres.
5. Do not put your used batteries, nickel cadmium, rechargeable, round cell or starter batteries in with your household
rubbish. Take them to an appropriate disposal/collection site.
SETUP INSTRUCTIONS
1
5
button once again to select the light shows in the following sequence:
button once after Show #6.
2
6
ON/OFF and
Light Show
Selections
Show #4 – Red Flashing
Show #5 – Green Flashing
Show #6 – Blue Flashing
3
x4
4
7
Werbung
Inhaltsverzeichnis
