Battery Charging - Mangar Health Airflo 12 Bedienungsanleitung

Airflo 12
Battery Charging - figs.
• Check the battery charger casing and lead
for signs of damage and if damaged DO
NOT USE.
• Fit the appropriate mains plug adaptor to
the battery charger (A).
• Plug the battery charger into a mains
power socket and connect the charger
output lead to the Airflo 12 charging
socket (B).
NOTE: When first fitting a battery they must
be charged for a minimum of 16 hours to
achieve full capacity. On subsequent charges
the Airflo calculates the charging period
based on usage and will not necessarily start
at the bottom light flashing.
When the battery is being charged:
• For the first 6 hours, the bottom light
will flash green. After 6 hours the first
light will become a steady green and the
second light will start flashing. Charging
cycle continues until all lights are lit.
• After 16 hours the charge will be
complete and the compressor will move
into an energy saving mode with the top
LED flashing every 6 seconds and the
other 3 will be off.
NOTE: If charging is momentarily interrupted (a power cut, switching the power socket off or
disconnecting the charging lead), on re-connection, the charging process will resume at the
same charge sequence point.
To maintain battery condition, it is recommended that the Airflo 12 is left continuously on charge
when not in use. The batteries cannot be overcharged using this charger.
WARNING: DO NOT recharge the batteries in a bathroom or in a damp environment.
6
2
2
GREEN
A
GREEN
GREEN
GREEN
First 6
Hours
B
GREEN
GREEN
GREEN
GREEN
16
Hours