Cleaning And Maintenance; Specification; Operation; Learn More - Rebel URZ1226-2 Benutzerhandbuch

Example*
1. Set the system code „123" on the remote control.
2. Set the system code „123" on all the socket switches. To assign a
code to switch "A", set the switch with the letter "A" in the upper
position.
Set a control key as well. In the figure the key pair „A" is set with DIP
switch A.

OPERATION

1. Plug this socket into a wall power mains socket.
2. Connect an external device into this socket.
3. Press the ON button on the remote control to turn on the
corresponding socket accordingly.
4. Press the OFF button on the remote control to turn off the
corresponding socket.
EN
14

CLEANING AND MAINTENANCE

Caution! Risk of electric shock.
1. Prior to cleaning, disconnect the device from power mains socket.
2. Make sure that no liquid gets into the device. The liquid inside the
device may lead to a short circuit.
3. Do not use any abrasives or chemical agents to clean this device.
4. Clean the device with a soft, slightly damp cloth.
5. Make sure the device is completely dry before next use.
6. Check battery level regularly..

SPECIFICATION

• Maximum power: 1000 W
• Remote control range: up to 25 m
• Remote control frequency: 433,92 MHz
• Battery: 1x A23 12 V DC
• Power supply: 220-240 V AC | 50-60 Hz
• In set: Remote control with batteries, Three switches

LEARN MORE

For more information on this device visit: www.rebelelectro.com.
Read owner's manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.
15
EN