First Use - Rebel URZ1226-2 Benutzerhandbuch

FIRST USE

1. Insert the battery into the remote control paying attention to the
correct polarity.
2. Synchronise the system code between the remote control and the
socket switches
3. Assign an ON/OFF key pair on the remote control to a socket switch.
SYNCHRONIZING THE SYSTEM CODE
Before using the device for the first time the system code must be
synchronized to enable all socket switches to react to the radio signal of
the remote control. Moreover, each socket switch must be assigned a
frequency of a key pair on the remote control to enable it to be operated
individually. Adjust the DIP switches using a suitable object, for instance a
small screwdriver, by pushing them down or up. The remote control
supports up to four sockets.
SETTING A SYSTEM CODE ON THE REMOTE
CONTROL
1. Remove the cover of the battery compartment.
2. Set any system code using DIP switches 1 to 5.
3. Close the battery compartment.
EN
12
SETTING A SYSTEM CODE ON THE SOCKET
SWITCH
1. Undo the screw of the cover using a PH0 screwdriver.
2. Slightly raise the cover above the screw hole and push out.
3. Set the same system code as for the remote control using DIP switches
1 to 5.
ASSIGNING A SOCKET SWITCH TO A CONTROL
KEY
1. Set a control key on the remote control using DIP switches A to D:
2. Push the cover in and close.
3. Insert the screw through the screw hole into the thread and tighten
13
EN