TFA 60.2503 Bedienungsanleitung Seite 10

TFA_No. 60.2503 Anleitung_03_21
Radio-controlled alarm clock with thermometer
• Low batteries should be changed as soon as possible to prevent
damage caused by leaking. Never use a combination of old and
new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when
handling leaking batteries.
Important information on product safety!
• Do not place your product near extreme temperatures, vibra-
tions or shocks.
• Protect it from moisture.
5. Elements
Front (Fig. 1)
A: Temperature display
C: Date with weekday
E: Alarm symbol
G: SNOOZE/LIGHT button
Back (Fig. 2)
H ALARM slide
▲ / 12/24 button
J:
18
17.03.2021 15:44 Uhr
B: Clock
D: DCF symbol
F: Light sensor
I: MODE/SET button
K: ▼ / °C/°F button
Seite 10
Radio-controlled alarm clock with thermometer
L: WAVE button
N: AUTO-LIGHT slide
6. Getting started
• Pull the protective foil off the display.
• Remove the battery insulation strip.
• The clock will scan the DCF frequency signal and the DCF symbol
flashes on the LCD. When the signal is received successfully after
3-5 minutes, the radio-controlled time and the DCF symbol
appear permanently.
• The clock automatically receives every day at 2:00 and 3:00 in the
morning a radio signal. If the reception fails, the symbol disappears
and scanning stops and will be repeated at 4.00 am and 5.00 am.
• Manual initialization can be helpful. Press and hold WAVE but-
ton. If the reception fails (10 minutes), the symbol disappears
and scanning stops and will be repeated in the next hour.
• Press and hold WAVE button, to stop the initialization.
• In case the clock cannot detect the DCF-signal (for example due
to disturbances, transmitting distance, etc.), the time can be set
manually. The clock will then work as a normal quartz clock.
(see: Setting of the clock and calendar).
• The manually set time will be overwritten by the DCF time when
the signal is received successfully.
M: RESET button
O: Battery compartment
19