Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.4 Blowing
Connect the suction hose (10) to the blow connector (9) on the
wet and dry vacuum cleaner.
MANUTENZIONE
Always remove the battery before carrying out any
work on the machine.
WARNUNG !
Cleaning
Keep all safety devices, air vents and the motor housing free of
dirt and dust as far as possible.
We recommend to clean the equipment immediately after you
use it.
1. Cleaning the appliance head
Clean the appliance regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance.
2. Cleaning the tank
The tank can be cleaned with a damp cloth and some soft soap or
under running water, depending on the amount of dirt.
3. Cleaning the cartridge filter
Clean the cartridge filter (15) regularly by carefully patting it and
cleaning it with a fine brush or hand brush.
4. Cleaning the foam filter
Clean the foam filter (16) with a little soft soap under running
water and allow it to air-dry.
5. Servicing
At regular intervals and before each use, check the filters in the
wet and dry vacuum cleaner are securely fitted.
Caution!
If something unusual occurs during use, switch off the tool and
remove the battery. Inspect and repair the tool before using it
again. Repair of the tool must only be carried out by a qualified
repair technician.
Repair or maintenance by unqualified personnel can lead to a
risk of injury.
Use only identical spare parts for repairing a tool.
STORING
Store the machine, operating instructions and where necessary
the accessories in the original packaging. In this way you will
always have all the information and parts ready to hand.
Pack the device well or use the original packaging in order to
avoid transit damage.
Always keep the machine in dry place.
I
100
101
GB
Werbung
Inhaltsverzeichnis
