Mäusbacher 0546 180-90 P1 Montageanleitung Seite 17

7. Setting the new lowest display and height range (7SH)
The desk frame ships defaulted to its minimum and maximum height limits. These steps allow the upper and lower limits to
be adjusted to your preference:
S
Press
button and hold for 3 seconds, handset display
.
Press UP or DOWN. It will display 7FS.
S
Press button to enter. It will display
: Sets the lowest position height display.
:Sets a new minimum desk height
:Sets a new maximum desk height
Press UP or DOWN. It will display
to set the lowest height display, press
Press UP or DOWN ,It will display
to set a lowest height position, press
Press UP or DOWN ,It will display
to set a new highest height position, press
8. Setting Constant-touch & One-touch for go Up or Down (8Hc)
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN. It will display 8Hc.
S
Press button to enter. It will display current mode
: Keep pressing UP or DOWN button to make the desk move up or down.
: Press UP or DOWN button and release, the desk will be moving up or down automatically; Press any button to stop the
desk when it's moving.
to confirm your preference, wait 2 seconds, setting is saved.
S
Press
9. Reminder setting (9St)
To get a healthier working style, the desk can remind you to stand up when you sit for a long time. You can set it by doing the
following:
S
Press button and hold for 3 seconds, handset displays
Press UP or DOWN go to display 9St.
S
Press to enter. It will display
Press UP or DOWN to select the time reminder you want, (
Note: When the handset time reminder beeps, press any button to make it disappear; the time reminder will last for 30 se-
conds if no buttons are pressed.
10. Setting bounce height (10H)
S
Press button and hold for 3 seconds, handset display
.
Press UP or Down to display 10H.
S
Press button to enter. It will show the current bounce height.
Press UP or DOWN to get the bounce height. Press
11. Restore Factory Defaults (11r)
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN to display 11r.
S
Press to enter. It will display
to confirm, wait 2 seconds, it will display the current height.
S
Press
12.Fatigue test mode (d)
Factory use, please ignore this programming.
, press UP or DOWN. It will display
S
, press button to enter. It will display the current lowest height. Press UP or DOWN
to confirm .
S
S
. Press button to enter. It will display the current lowest height. Press UP or DOWN
to confirm .
S
S
. Press button to enter. It will display the current highest height. Press UP or DOWN
to confirm .
S
. Press UP or DOWN, it will display
. 0.0 is the standard and means no time reminder (H means Hour).
to confirm, wait 2 seconds, it will display the current height.
S
and flash.
S
. Release button, press
and
S
. Release button, press
S
. Release button, press
means 1.5 hours), press
S
. Release button, press
S
. Release button, press
E-MORE 2M2S / 2M3S TQD
S
button again to enter, it displays
.
S
button again to enter, it displays
.
S
again to enter, it displays
to confirm.
S
S
button again to enter, it displays
S
button again to enter, it displays
.
15