Operation - ZAMEL Exta free P-256/8 Kurzanleitung

OPERATION

After pressing the push-button the remote control sends a signal on
868 MHz which controls EXTA FREE receivers. Device programming
procedure (adding a transmitter to the transmitter's memory) is
described in manual instruction of particular EXTA FREE system
receivers. The range (up to 300 m depending on a receiver) can be
changed by means of a retransmitter or few RTN-01 retransmitters.
BATTERY CHANGE
Battery discharge status is signalled by several LED red diode
flashes during transmission time.
Remove the screws from the bottom part of the remote control.
Remove the upper cover with the silicon keyboard.
Remove the battery from the latch.
Mount a new battery. Watch battery polarisation marked on the
latch. Wrong battery mounting may cause device damage.
Place back the top cover with the keyboard and tighten the screws.
CAUTION: While changing the battery, it is suggested to press any of the but-
tons for about 5 seconds before putting it into a latch. Next press transmission
button several times to check its operation. If the transmitter does not work
properly repeat the battery change procedure.
SUBSTITUTING THE BATTERY WITH ANY BATTERY OF INCORRECT TYPE
DISPOSE OF USED BATTERIES AS STATED IN THE MANUAL.
COOPERATION AND OPERATING RANGE
ROP-
Symbol
01
RNK-02 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
RNK-04 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
P-256/8 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
P-257/4 (2) 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
RNМ-10 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
RNP-01 160 m 180 m 180 m 180 m 180 m 200 m 200 m 200 m 160 m 200 m
RNP-02 160 m 180 m 180 m 180 m 180 m 200 m 200 m 200 m 160 m 200 m
RNL-01 160 m 180 m 180 m
RTN-01 200 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 200 m 250 m
RCR-01 160 m 180 m 180 m
RXМ-01 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
* 1-channel transmitters do not cooperate with roller blind controllers.
CAUTION: The given range concerns open area - an ideal condition without any
natural or artificial obstacles. If there are some obstacles between a transmitter
and a receiver, it is advisable to decrease the range according to: wood and plas-
ter: from 5 to 20 %, bricks: from 10 to 40 %, reinforced concrete: from 40 to 80 %,
metal: from 90 to 100% , glass: from 10 to 20 %, Over- and underground medium
and high electrical power lines, radio and television transmitters, GSM transmit-
ters set close to a device system have also a negative influence on the range.
MAY CAUSE AN EXPLOSIVE HAZARD.
ROP- ROB- SRP-
02 01 02
lack*
lack*
SRP- RWG- ROМ-
03 01 01
lack* 200 m 200 m 200 m 160 m 200 m
lack* 200 m 200 m 200 m 160 m 200 m
ROМ- RDP- RTN-
10 01 01