Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention:
• Pressing and holding the control dial switches the lamp on/off.
• Briefly pressing the control dial switches between brightness and colour temperature.
To charge the lamp, open the USB cover on the back.
To charge, use the supplied USB cable on the input
labelled „Input". Connect the other side of the cable
to a standard 5V adapter (not included), which is
plugged into a mains socket (follow the instructions
for the adapter). To charge an electronic device using
the lamp, plug the supplied cable into the USB port
marked „Output" and connect the other side to your
electronic device (also refer to the operating instruc-
tions for your device). The charging process starts
automatically.
Changing the batteries
After about three years, the capacity of the recharge-
able batteries will decrease and they must be repla-
ced. The batteries are commercially available (batte-
ry type 18650). To replace the batteries, proceed as
follows: Open the housing at the bottom of the lamp
with a screwdriver. Remove the inserted batteries and
insert batteries of the same type with the correct po-
larity. Close the cover and carefully screw the screw
back in. The lamp is now ready for use again.
Notes:
• Batteries do not belong in the hands of children. Never leave batteries lying around open-
ly, as there is a risk of them being swallowed by children or pets.
• Batteries must never be short-circuited, disassembled or thrown into a fire. There is a risk
of explosion.
• Leaking or damaged batteries can cause burns if they come into contact with the skin. In
this case, use suitable protective gloves.
• When changing batteries, only use batteries of the same type! Non-rechargeable batte-
ries must never be used.
• Make sure that the polarity is correct when inserting the batteries.
• If the batteries are not used for a longer period of time (e.g. during storage), remove them
to avoid damage caused by leaking batteries.
Werbung
