Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• 1x CSL Pedals (2x Edge Protector 1.5 mm pre-installed)
A
• 2x Hard Mount Spacer
B
• 2x Edge Protector 2.5 mm (Adhesive Included)
C
• 8x M4x12 mm Countersunk Mounting Bolts
D
• 1x RJ12 Cable
E
• 1x T20 Torx Key
F
Use either the pre-installed 1.5 mm or 2.5 mm edge protectors (C) (including adhesive) when using the
2D
pedals on a floor.
Hard-mount using all four mounting holes (bolts are not included).
3A
Download
drilling template
4A
Connect the brake pedal lever unit cable to the "Brake" port.
4B
CSL Pedals Clutch Kit (Sold Separately).
4C
Port only for Wheel Base or CSL Pedals Load Cell Kit.
ATTENTION!:
Connecting any other pedal or peripheral to this port may cause permanent damage!
Update your wheel base firmware. You can obtain the latest driver from fanatec.com/downloads. Follow the
instructions provided by the
NOTE:
In order to update the firmware of this product, a PC is mandatory and PC mode must be active on the
wheel base.
6
Our Support Team is ready to help you! Visit
fanatec.com/support/faq
Download our app:
Fanatec.com/app
This product is under warranty of Endor AG. Refer to the included warranty sheets as well as the terms & conditions
Quick Guide
1
PACKAGE CONTENTS
2
PEDAL ADJUSTMENT
3
HARD - MOUNTING
from the product page on Fanatec.com.
4
CONNECTIONS
5
Driver & Firmware Instruction Manual
SUPPORT
for assistance.
of Endor AG on Fanatec.com.
For compatibility information, visit the product
page on Fanatec.com.
ATTENTION
which can be found on the product page.
Watch our
Fanatec.com/QR/CSL-P
3B
M6x(22+X) mm
7
VIDEO
CSL Pedals
video guide:
4
Werbung
