Vestfrost CFS344STS Bedienungsanleitung Seite 4

CONTENTS
1. Before starting the appliance.
2. How to use the appliance.
3. Maintenance.
4. Has the appliance stopped working?
5. Safety.
6. Technical data.
7. Installation.
8. Electrical requirements.
9. Change of hinge side.
10. Changing the light bulb.
1. BEFORE STARTING
THE APPLIANCE
Check that the cabinet is undamaged. Please
report any damage immediately to your dealer.
Wash the cabinet and inner lining with a mild
unscented detergent and wipe it dry. Do not use
abrasive scouring powder, steel wool or similar.
Connection to the electricity supply: See head 7
and 8.
2. HOW TO USE THE APPLIANCE
Operating panel (see fig. (1) page 16.
1. Thermostat knob.
2. Indicator for the connection to the electricity
supply (green).
3. Switch for light.
The thermostat knob is adjustable from 0 (stop) to
7 (coldest). Find the position of the thermostat
which gives you the desired temperature. Start at
position 4.
DEFROSTING THE FREEZER
The goods and the humidity of the air will gradually
cause frost and ice to form in the freezer unit. A
thin layer of frost or ice does not affect the
functioning of the freezer, but the thicker the coa-
ting, the higher the energy consumption. A little
loose frost can be scraped off with a plastic or
wooden scraper. (Never use a knife or other sharp
tool, as this may damage the evaporator unit).
When the frost and ice is about 4-5 mm thick, the
freezer must be defrosted. Do this as follows:
1. Switch off the unit by turning the thermostat
knob to zero.
2. Pull out the spout at the bottom of the freezer
and put a bowl under it.
3. Take the food out. Keep it in the fridge or pac-
ked in newspaper to keep it as cold as possible.
4. Placet a bowl of hot (not boiling) water in the
freezer.
5. When the ice has melted, clean the freezer
with water and a little detergent. Wipe dry with
a soft cloth.
4
6. Set the thermostat button again. Push in the
freezing button if there is a lot of food to be
put in the unit.
7. Put the food in again when the temperature
has reached -18
freezer thermometer (it takes about an hour).)
8. Switch off the freezing button.
3. MAINTENANCE
Only use an unscented detergent when cleaning
the cabinet inside.
You may remove the top panel and wash it when
cleaning the cabinet inside.
Switch off the appliance and pull out the plug
when cleaning the cabinet.
The skirting board can be removed to facilitate a
vaccuum-cleaning of the floor. See fig. (4) page
17.
To make the cooling system work at its optimum it
is necessary from time to time to clean the wire
condenser and the compressor at the back of the
cabinet by means of a brush or a vaccuum cleaner.
Remember to clean the drain.
IMPORTANT!
In case of damage to the power cord it must be
replaced by a power cord of corresponding type,
available from the manufacturer or his service
representative.
4. HAS THE APPLIANCE STOPPED
WORKING?
Before calling a repairman, check that
l The plug is properly plugged into the wall
socket.
l The fuse is intact.
l The power has not been cut off.
l All controls are correctly set.
l Switch off the cabinet for 15 minutes (for
instance at the thermostat). Switch it on again
and after 5 minutes check whether frost has
formed on the evaporator.
l Do not open the cabinet when unnecessary.
DISPOSAL OF THE APPLIANCE
The appliance contains recyclable materials.
When disposing of the appliance, please
contact the technical administration or other
appropriate authority in your municipality.
They can inform you of the collection and
recycling measures used in the municipality.
0
C - you can see this on the