Mtx Wall Panel Connection Possibilities - AUDAC MTX Serie Bedienungsanleitung

Line Level audio source can be connected, such as CD-Player, MP3-Player, Computer,
Laptop, ... The stereo signal is converted into a dual-mono signal and is transferred from
the input unit to the MTX in an analogue differential way which is insensitive for noise or
interferrence caused by external devices.
The Microphone input units (WMI) are equipped with a female XLR connector, whereto any
kind of balanced microphone can be connected. For powering condensor microphones, 12
Volt phantom power can be enabled by a jumper on the rear side of the unit. The signal
is transferred from the input unit to the MTX in an analogue differential way, which is
insensitive for noise and interference caused by external devices.
The signal coming from the line input unit will be available in input 7 of the corresponding
zone, and the signal coming from the microphone input unit will be available on input 8 of
the corresponding zone. Two input units (one WLI and one WMI) can be connected in bus
structure to one WP input. The inputs from the MWX65 and the inputs from the WLI are
both available on input 7. This means that only one of these inputs can be connected at a
time.
The connection of the WLI and WMI units should be done by using Cat5e (or better)
cabling and the maximum cable length to the MTX is 300 meter.

MTX Wall panel connection possibilities

This section provides an overview for the wall panel connection possibilities on the MTX.
In reality there are many more combinations possible than described here, but with these
few examples and the brief description it should be clear which connections solutions will
work and which solutions won't work, and why.
Multiple MWX43/45 Wall panels can be connectTed on one Wall Panel Input.
They can be configured to control all the same, or different zones.
MTX88
PAGING WP WP WP WP WP WP WP WP
AUDAC
WP
Zone 8 Zone 7 Zone 6 Zone 5 Zone 4 Zone 3 Zone 2 Zone 1
RS-232
ETHERNET
AC Input
100-240V 50/60Hz
Fuse: T1AL/250V
Multiple MWX43/45 and one MWX65 Wall panel can be connected on one Wall Panel Input
They can be configured to control all the same, or different zones. The audio input of the MWX65 can only
be routed to the zone its connected to.
MTX88
PAGING WP WP WP WP WP WP WP WP
AUDAC
WP
Zone 6 Zone 5 Zone 4 Zone 3 Zone 2 Zone 1
Zone 8 Zone 7
RS-232
ETHERNET
AC Input
100-240V 50/60Hz
Fuse: T1AL/250V
Caution: Only use
LOW MID HIGH LOW MID HIGH
fuses of the same type
Warning: Do not
expose this equipment
to rain or moisture
-15 +15 -15 +15 -15 +15 -15 +15 -15 +15 -15 +15
Mic 2 Mic 1
GAIN GAIN
PHANTOM PHANTOM
Line 6 Line 5 Line 4 Line 3
-50 0 -50 0
GAIN GAIN GAIN GAIN
-14 +9 -14 +9 -14 +9 -14 +9
CLIP CLIP
CLIP CLIP CLIP CLIP
Caution: Only use
fuses of the same type LOW MID HIGH LOW MID HIGH
Warning: Do not
expose this equipment
to rain or moisture
-15 +15 -15 +15 -15 +15 -15 +15 -15 +15 -15 +15
Mic 2 Mic 1
GAIN GAIN
PHANTOM PHANTOM
Line 6 Line 5 Line 4 Line 3
-50 0 -50 0
GAIN GAIN GAIN GAIN
-14 +9 -14 +9 -14 +9 -14 +9
CLIP CLIP
CLIP CLIP CLIP CLIP
+ + + + +
Prog. Prog. Prog. Prog. Prog.
-
- - - -
+ +
+ + +
Vol
Vol Vol Vol Vol
- -
- - -
+ + +
Prog. Prog. Prog.
LINE IN - - -
+ + +
Vol Vol Vol
- - -
MIC IN
AUDAC
+
Prog.
-
+
Vol
-
41