Ready - AUDAC MTX Serie Bedienungsanleitung

To configure the settings of the MWX65 wall panels, go back to the "Setup" > "System
configuration" menu, and click the "MWX65" button.
After this button is clicked, a window will be shown where all the configuration settings
for the MWX65 can be made. On the left side, a dropdown list is shown whereby the
address for the MWX65 can be selected. The address can be selected between "W001"
to "W008". Logically it starts with the address "W001" for the first wall panel and
increases the address for every subsequent wall panel. After the desired address is
selected, click the "Set Address" button and the display on the MWX65 will start blinking.
Confirm the address of the wall panel by pushing the big rotary button on the wall panel
and the selected address will be assigned to the wall panel.
After this is done, the zone which should be controlled by this wall panel can be selected
by the dropdown list which is shown one position to the right.
The inputs which are selectable with the wall panel can be chosen in the "Selectable
inputs" dropdown list. After the inputs are clicked, all the selected inputs will appear in
the listbox shown below.
Certain actions such as Volume Change, Input change, Mute, Tone control and settings
can be disabled from the wall panel and the phantom power on the microphone input can
be enabled by clicking the check boxes.
Finally, the display backlight level and screensaver settings can be adjusted.
After all settings are done, click the "Save to Wallpanel" button and all your settings
. R
will be send to the selected MWX65 wall panel epeat this action for all the connected
MWX65 Wall Panels.

Ready

Your system is now completely configured and ready to be used.
22