CSL 27999 Benutzerhandbuch Seite 10

6 Establishing a connection in "Transmission mode"
In this mode you can transmit music from devices without a Bluetooth interface
to a Bluetooth player.
First make sure that the 2in1 Transmitter/Receiver is switched off (the LED next to
the 3.5 mm stereo jack socket is off).
Set the switch to position TX to activate transmission mode.
Now connect the 2in1 Transmitter/Receiver to the signal output of your music
player using the enclosed stereo jack cable.
Hold the On/Off button on the 2in1 Transmitter/Receiver down for approx. 10
seconds until the LED starts to flash blue. Now activate the Bluetooth link mode
on your receiving device such as a Bluetooth speaker. The 2in1 Transmitter/Re-
ceiver will now automatically connect to the receiving unit.
Note: Please make sure that no other devices are in link mode when you make the
connection. How you change your receiving device to link mode is described in the
relevant operating instructions.
7 Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the device
to sudden changes in temperature or heavy vibration as this might damage
electronic components.Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe national regulations and restrictions.
Do not use the device for purposes other than those described in the instruc-
tions. This product is not a toy. Keep it out of the reach of children or mentally
impaired persons. Any repair or alteration to the device not carried out by the
original supplier, will invalidate the warranty or guarantee.The product may only
be used by persons who have read and understood these instructions. The device
specifications may change without any separate prior notice to this effect.
10
English