Cut Out For Touch Sft Multifunction Control Panel; Tank Sensors - Thetford Marine COMPACT LINE Aufstellungs- Und Gebrauchsanleitung

*To install the Chorus line (Gewiss) remove the fins from the Frame B (see the picture)

Cut out for Touch SFT Multifunction control panel:

4.6

Tank sensors

The sensor wiring of the control units, both in the standard one-level version (grey / black),
and in the two-level version for Touch (red / black and white / green) have a voltage of 7V.
You can connect:
• Sensors with clean contact (float, with pressure switch or similar) which close the
contact between the two poles of the connector.
• Electronic sensors with the following specifications:
o Power 7V.
o Electrical absorption 12,75 mA +/-1 mA when the sensor is un-activated and
22,75 mA +/- 1 mA when activated.
WARNING: In any case, do not connect the sensor cable to any power source.
NOTE: For the compatibility of the control units with other types of sensors or for the
use of connections other than those indicated in the wiring diagrams, contact the
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Compact line | Installation and use manual | ENG
59
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com