Mounting The Sensor - Freudenberg LeaCo Bedienungsanleitung

Mounting the sensor

Attach the enclosed metal plate to the surface where
the leakage is expected and attach the sensor using
the magnet on the back
Alternatively, you can also mount the sensor with
screws by using the mounting brackets. If these brack-
ets are not needed, they can be broken off at a prede-
termined breaking point.
Important: The sensor must be mounted in such
a way that the liquid can drip onto the non-woven
fabric on the back from above in case of leakage
20
4 .
3
Start-up
Start-up of the display module
1. Screw the external antenna into the thread
provided
2. Connect the display module to the power supply
using the USB cable and the power plug
3. Switch on the display module
and confirm the safety instructions.
If you only want to see alarm messages on
the display module and not on your smartphone,
continue with step 8. To connect to your smartphone,
continue with step 4.
4. Insert your activated SIM
card into the SIM card slot
8
until it clicks into place.
5. Go to «Settings» (
6. Go to «PIN» and enter the PIN of your SIM card. Then
confirm with «OK». Go to «Phone number 1» and
enter the phone number of your smartphone. Then
confirm with «OK».
7. Under «Phone number 2» you can connect another
mobile device.
.
5
.
6 , select the language,
)
EN
9
.
21