Preparation For Use; Heating The Sauna - HUUM HIVE Heat Montage- Und Bedienungsanleitung

APPLICATION INSTRUCTION

Preparation for use

• Any natural granite stones or special sauna stove stones sold at
hardware stores are suitable for the sauna stove. Use of ceramic
stones may shorten the life of the stove.
• The stones must be washed clean before laying.
• Sauna stove stone quantity:
• HIVE Heat 12: 6 x 15 kg.
ATTENTION! The sauna stove can only be heated with wood logs.

Heating the sauna

• Avoid overheating the sauna stove; overheating is indicated when
the furnace case glows red. Overheating causes the metal to
deform, and the manufacturer is not responsible for this defect.
• In the case of overheating, the ash tray must be completely
closed to stop the furnace combustion process. Keep the
furnace door closed. If possible, cut off air flow to the room.
• It is recommended each time you heat the sauna stove that
some quantity of the fuel consists of small and easily flammable
pieces of material which are more porous and lighter compared
to the rest of the fuel quantity.
• The sauna stove can only be heated with wood logs. For HIVE
Heat 12, 30 cm logs are best suited.
• If necessary, the supply of combustion air can be adjusted
by controlling the draught of the air vents in the front side
of the heater by changing the position of the shutter. It is
recommended to keep the ash tray open by up to 2 mm for
ignition. During heating, it is recommended to keep the air vents
fully open at the top of the front side of the heater.
• Keep the furnace door closed during heating. Open the door only
to add firewood.
7