Technical Data - KaWe MedCharge 4000 Gebrauchsanweisung

Warnings:
1. Follow additional requirements specified in user's manuals for rechargeable batteries for
the charging time.
2. Caution! Do not use dry batteries - risk of explosion!
3. Before installation, check that the mains voltage used is within the permissible range (see

technical data).

4. After charging has been completed, remove the battery handles from the device and
disconnect the power cable of the charger from the mains.
5. The device may only be used in closed, dry rooms.
6. Do not use the charger in areas subject to strong magnetic fields (MRI systems).
7. Do not clean the inside of the charger as this could cause a short circuit.
Maintenance: After the power supply plug has been plugged into the outlet, the charger is
ready for use (the green LED will read: „Standby"). After the battery handle have been inserted,
the LED of the corresponding charging socket signals the charging status (red = charging,
green = fully charged, blinking red = error). After the charging voltage has been reached,
the LED switches from red to green, i.e. the battery handle is fully charged. When the handle
is inserted into the socket, the charging process starts automatically. If necessary, a take-up
sleeve is used as an adapter for the various handles. After unscrewing the cover, the battery
can be removed or replaced.
Technical data:
- Input voltage .....................................100 V–240 V +/- 10%, 50–60 Hz
- Power factor ......................................>0.99
- Chargeable elements ........................NiMH and Li-Ion
- Number of elements .........................NiMH 2–3 elements, Li-Ion 1 element
- Chargeable capacity ..........................min. 250 mAh, max. 4500 mAh
- Charger input voltage .......................8.55–9.45 VDC
- No-load power consumption ...........< 0.5 W
- Rated power consumption ...............about 4.5 W
- No-load output voltage ....................< 9 VDC
10