EN-8
4. Operation
4.1. Operation Instruction
After installation, if you need to use the scale for trade, you need to give
the scale to local metrology department or national metrology
department for verification before use.
The scale needs to be warmed up for 30 minutes. Please refer to
scale's technical manual for detailed operation.
Metering must be performed when the "Zero Center Cursor "light on the
meter is lit.
4.2. Precautions
For continued best operating
•
Avoid falling loads, shocks and hard lateral
impacts
•
When weighing, all items should be
centrally located on the floor scale and not
over hanging the sides or the ramps.
•
Verify the calibration of the floor scale
system at regular intervals.
•
Though the floor scale boast a relative
strong structure, the weight placed must be
within the allowed range.
Defender Series Floor Scale
performance::