Herunterladen Inhalt Inhalt Diese Seite drucken

Device Installation - Blaupunkt VIO-B10/B30 Kurzanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10

4. Device Installation

4.1 IMPORTANT – Read before installing
 Before the installation, please make sure the installation environment can at least support 3x weight of the
camera.
 Check your Wi-Fi signal strength. To make sure that your camera's connection is as stable as possible, make
sure that the Wi-Fi signal is very strong at the location of your camera. The suggested Internet bandwidth is
1Mbps (upload/download speed).
 For best performance, the smart-mobile device(s) need to be on Wi-Fi or 4G mobile network to receive
maximum download speed.
 Avoid aiming the lens at the strong radiation source directly (such as sun, laser etc)
 If you desire to install a MicroSD card, we recommend doing it before the installation process. Please refer to
"4.3 MicroSD installation" for more information.
4.2 Ceiling / Wall Installation
 S tep 1
Find the desired installation place for the camera. Position the camera according to the area you would like to
monitor. Please mind that a power socket is in sufficient proximity. Check the WIFI signal and ensure that the
desired monitoring area is in view by using the "Live View" option.
 S tep 2
Place the camera on the desired position and mark the three needed drilling holes with a pencil on the wall.
 S tep 3
Drill the 3 mounting holes on the installation surface (wall or ceiling).
 S tep 4
Drill a 20mm diameter hole for the Ethernet Network port and Camera Power connector, if you want to lead the
cables through the wall or ceiling.
Note: If due to special circumstances, such as a reinforced concrete wall, it's not possible to drill a hole of 20mm
diameter, you have the option to cut off the thick Ethernet Network port - see "Chapter 2. Product Appearance", and
seal it with a proper sealing tape. With this option a 12mm diameter drill is needed.
Alert: If you decide to cut off the Ethernet Port, you will lose the possibility to connect the camera by
Ethernet cable to a router or NVR. Additionally, you lose your right of return.
Installation
Camera
Screw
Installation
Plastic
Surface
dowel
6

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis