Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instruction EN
Návod k obsluze CZ
2. WARRANTY SERVICE
The warranty is subject to Terms and Conditions and
Warranty Conditions of IGM nástroje a stroje s.r.o.,
the current version of which are available at www.
igmtools.com.
3. SAFETY INSTRUCTIONS
3.1 Notice
Warning: failure to comply with these rules can result
in the risk of serious injury.
This machine is intended for feeding wood to be cut.
Working with other materials is not permitted but can
be allowed after consultation with the manufacturer.
Comply with the minimum age limits specified by
law. The machine may only be used when in perfect
technical condition.
In addition to the operating instructions read the
safety instructions and also comply with any and
all special regulations of your country. You should
adhere to the generally recognized technical
and safety rules concerning the operation of
woodworking and metalworking machinery.
The manufacturer or the supplier is not responsible
for any damage resulting from improper use. Every
user is responsible for their own actions.
3.2 General safety instructions
The machine can pose danger when improperly
operated.
Completely read the operating instructions before
working with the machines and follow all the
instructions in this manual.
Keep this user manual clean and protect it from dirt
and moisture; in case of re-selling, pass the manual
onto the new owner.
Any alterations or changes to the machine are
prohibited.
Daily try out if the machine runs smoothly and check
the function of protective covers before operating
the machine. Repair any malfunctions or deficiencies
found on the machine.
A damaged protective cover must be replaced
immediately. The machine may only be used when in
perfect technical condition.
Use a hairnet or a hat to protect long hair. Wear
tight-fitting clothes, remove all bracelets, rings,
necklaces or ties. Wear work boots only, do not wear
casual shoes or sandals during work. Abide by the
regulations for personal protection.
Always wear safety eyewear. Always use hearing
protection. The tools are sharp and may improper
24
handling may lead to serious injury, always work
carefully. Keep in mind the necessary space for
operation when installing and positioning the
machine. The machine must stand on a stable surface
and must be adequately lit.
Always use respiratory protection when working in a
dusty environment.
Make sure you have good lighting.
Make sure the power cord is not in your way when
working. Keep your work area clean. Never touch the
machine when it's running.
Make sure you are concentrating and paying
attention. Use caution. Never work under the
influence of drugs and/or alcohol.
Make sure there are no children around when
working with the machine. Never leave the machine
unattended. Always switch the machine off when
leaving the workspace.
Watch your fingers and other body parts when
working. Never walk away from a machine without
protective guards.
Do not place anything on the machine.
Electrical connection malfunctions can be repaired by
an electrician only.
Damaged electric cord must be replaced
immediately. Any adjustments and maintenance may
be carried out when the machine is disconnected
from the power source.
3.3 Risks
Risks may arise even during proper and prescribed
use of the machine.
Danger of a workpiece flying off. Beware of noise and
dust.
Wear eye, ear and dust protection. Use a suitable dust
extraction device!
Watch out for damaged electrical cords.
3.4 Important safety notifications
Do not use the feeder in a dangerous environment.
Keep your workspace well ventilated and lighted,
avoid wet or damp environments. Only operate the
machines under temperatures ranging from +5°to
+40°C.
3.5 Safety rules
The tool must reach working speed before feeding.
Do not overload the machine by feeding material too
quickly.
ALWAYS keep your hands away from rotating parts.
Provide additional support and stability for larger
www.igmtools.com
www.igm.cz
Werbung
Kapitel
Inhaltsverzeichnis
