Getting Started; Troubleshooting - Jays s-Go Mini Benutzerhandbuch

EN English

Getting started

Power on/off and pairing
To power on, press and hold the on/off button for 2s, the LED will
flash as it enters Bluetooth connection mode. To pair, go to
Bluetooth® settings on your device and select "Jays s-Go Mini". The
blinking LED will turn into a constant light upon a successful
connection followed by a short audio beep.
To power off, press and hold the on/off button for 2s, the LED will
turn off.
Reconnecting
Next time you power on, the s-Go Mini will automatically try to
reconnect to the most recently used device. If not found, or if you
manually disconnect through your device, pairing mode will
automatically be initiated again. To force pairing mode, press and
hold the on/off button for 5s from off state.
True wireless function
This speaker is true wireless. This means you can connect other
compatible speakers to create stereo sound. Before connecting to
your device, press the Play/Pause button for 2 seconds to enter TWS
connection. Once connected, long press to disconnect TWS
connection.
Bluetooth connection status
Double press the on/off button to disconnect the current connection
and double press to connect to the last disconnected device.
Battery status and charging
When paired with iOS devices, the battery status of the speaker is
shown in the upper right corner on the iOS device.
Charge by connecting the included USB cable to the USB jack and
connect it to any certified USB power output. A full 100% charge will
take around 2-2,5 hours (depending on temperature and charger).
Charging is indicated by a solid red light on the charging LED, and a
full charge is indicated by the LED switching off.

Troubleshooting

Problem pairing and connecting
• Make sure the speaker are not connected to another device.
Disable and enable Bluetooth on your device
• Move the speaker closer to the device or alter their positions
to avoid Bluetooth interference
• Verify no other wireless equipment interfere with your
earphone Bluetooth signal
• Reset the speaker by pressing the power button for 8
seconds.
Problem with sound transmission
Move the streaming device to another position. Your body,
distance, different materials and other wireless equipment can
interfere with the wireless signal between your device and
earphone.
FAQ and quickstart guide
Visit jaysheadphones.com for more instructions and help on
this product.