Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User manual
CentroGrip
Important notes:
Before clamping the CentroGrip tool holder, collet, nut and tool shank need to
be cleaned!
Assembling collet and clamping nut:
Insert the groove of the collet at the marked point in the excentric ring of the
clamping nut. Tilt the collet in the opposite direction, until you hear a click. Now
you may screw the clamping nut with the collet onto the thread of the holder.
Then tighten the lock nut with a torque wrench.
Recommended tightening torque:
Collet
Ø (mm)
MR11
1,0 - 2,9
3,0 - 6,0
MR16
1
1,5 - 3,5
4,0 - 4,5
5,0 - 10,0
MR25
1,0 - 3,5
4,0 - 4,5
5,0 - 7,5
8,0 - 16,0
MR32
2,0 - 2,5
3,0 - 20,0
The maximum tightening torque may not be more than 25 % above the recom-
mended values. A higher torque means higher load on the collet chuck.
Dismantling collet and collet nut:
After removing from the holder, press the front of the collet and simultaneously
remove the collet with pressure on the rear part, opposite to the mark.
www.HSK.com
Helmut Diebold GmbH & Co. • Goldring-Werkzeugfabrik • An der Sägmühle 4 • 72417 Jungingen
Tel.: +49 7477 871 - 0 • E-Mail: info@hsk.com
Tightening Torque (Nm)
MR
8
20
40
56
24
56
80
104
24
136
Tightening Torque (Nm)
MRM
8
16
8
20
24
24
Werbung
