Control Panel - Polar G-Serie Bedienungsanleitung

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position
OR
Level the appliance by adjusting the screw
feet.
Mounting the castors
Note: The appliance is supplied
with feet by default. However,
castors can be supplied as an
option. Castors can be ordered
using the code of AJ450.
To replace with the castors, follow below steps:
1. Remove the feet support.
2. Attach the castor support.
4
CM530-CM532_ML_A5_v5_20200401.indb 4
3. Fix the castor support in place with screws.
4. Mount the castor.
Operation

Control Panel

Battery compartment
Temperature Display
RUN indicator
Thermostat
2020/4/1 17:07