Dmx Control; Maintenance / Cleaning; Troubleshooting; Technical Specifications - Laserworld Evolution Serie Bedienungsanleitung

Manual / Bedienungsanleitung: ES-50 G

DMX control

Channel

Maintenance / cleaning

Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 4 screws on the front panel, carefully remove the
connector to the LEDs on the front plate, remove back panel and slide mounting plate out.
Remove any deposits of dust, especially at the fan. Check for condensed fog fluid inside, if so,
clean and rearrange the position of laser and or hazer.
noticeable around the beam, or an unusual high amount of diffuse light can be seen inside the
device.Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.

Troubleshooting

Problem
No function / fan not working
Effects don't change to the beat of the music Adjust sensitivity with the dial on the front.
Problems with DMX control
Device not working, but fan working

Technical specifications

•
Power supply: AC 85-250V, 50/60 Hz
•
Ambient temperature: +10°C ... +35°C
•
Power consumption: 15 W
•
Operation modes: DMX 512, automatic, music mode
•
Lasersources: aircooled DPSS laser
•
Optical power (at the laser):
•
Beam: ca. 3mm/1mrad
•
Laser class: 3b
•
Scanning system: open loop galvos, 10000 PPS
•
Weight: 3.5 kg
•
Dimensions: 23 x 24 x 13 cm (W x D x H)

Please note

This device has left our premises in absolutely perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessary for the user to follow the
safety instructions and warning notes written in this user manual.
Laserworld cannot be made liable for damages caused by incorrect installations and unskilled
operation!
This manual is subject to changes without notification. Contact your local dealer for an update, or
check our website www.laserworld.com
For service contact your dealer, or Laserworld.
Value Function
0 – 50 Laser off
51 – 101 Built in effect selection
1
102 - 152 Pattern effect control
153 – 204 Automatic mode
205 - 255 Sound mode
2 0 - 255 Patterns / animations
3 0 - 255 25 effects
4 0 - 255 Effect speed
ES-50G DMX:
ES-100G DMX:
Mirrors need cleaning, when a "halo" is
Possible cause
Check mains connection
Check if device isn't in DMX or autom. mode
Check DMX address selection
Turn device off for ca. 1 Minute.
max. 50mW, >40mW 532nm green
max. 100mW, >80mW 532nm green
Page / Seite 5 of / von 10
Version / Stand: 03/2010