krispol STARCUS ONE Bedienungsanleitung Seite 5

IMPORTANT!
1. The batteries must be replaced when the integrated LED does not light, alternatively when
the receiver stops responding at the moment of pressing the keys.
2. When replacing the battery, it is necessary to pay attention to its correct polarity.
3. SELECTION OF ACTIVE CHANNELS
The function relates to 15-channel remote controls.
Pressing the UP or DOWN button will cause exit from the active channel selection mode. In order to
change the number of active channels again it is necessary to perform the procedure below again.
We simultaneously press and hold
the CHANNEL + and CHANNEL - buttons.
The „C" symbol will appear on the display,
and after about 4 seconds the number 15
and the up and down arrows.
4. PROGRAMMING THE FIRST TRANSMITTER FOR THE ER TYPE DRIVES
1. The programming of the transmitter depends on the type of receiver. When programming, it is necessary
to be guided by the instruction manual of the device which is to be controlled by the transmitter.
2. A pause longer than 5 seconds between successive presses of the button will automatically cause
exit from the programming mode without any introduced changes.
3. Adding a transmitter using this method will cause erasing the memory of the receiver.
4. When the „O" channel is set on the display, it is switched on the group channel enabling simultaneous
control of all roller blinds that are programmed on individual channels. We do not perform any
programming procedures on this channel. The group channel is created automatically.
LUB
We turn on the The drive will
power supply emit a sound.
or press the The roller blind
programming will make short
button on the up / down
drive head. movements.
ENVIRONMENTAL PROTECTION
This device has been marked in accordance with the WEEE Directive
(2002/96 / EC) regarding waste electrical and electronic equipment. By
ensuring proper scrapping you contribute to reducing the risk of occurrence
of a negative impact of the product on the environment and human
health, which could exist in the event of improper disposal of the device.
or CHANNEL - we set the number
Press the The drive will
programming emit a sound.
button (P2)
on the remote
control.
Using the buttons CHANNEL +
of displayed channels.
Press the The drive will
programming emit a sound.
button (P2)
on the remote
control.
The symbol placed on the product or the documents attached to it
means that this product is not classified as a household waste. The device
must be given to an appropriate waste disposal point for recycling. For
additional information regarding recycling of this product please contact
your local authority representative, a waste disposal service provider or
a store where the product was purchased.
Using the STOP button, we confirm
the setting. The symbol „o" is visible
on the display.
We press the UP The roller blind
button once. will make short
up / down move-
ments and emit
several sound
signals.