Operation Collector Installation Grip - Solvis SolvisFera Bedienungsanleitung

EN 1 Operation Collector Installation Grip

1 Operation Collector Installation Grip

The collector grip set consists of four grips. For transport
and during installation, the grips can be attached to the
collector quickly and easily.
Attaching the collector grip
1. Position the two wing nuts horizontally, so that the T-
heads are also horizontal.
2. Attaching the collector grip: The short side of the
folded sheet rests against the lower side of the collec-
tor. The T-heads sit in the slot of the collector frame.
Position the grip:
• LU-23x: no more than 10 cm from the corner
edge of the collector frame, according to
re 1, p. 2.
• SolvisFera: according to
Fig. 6: Inserting the T-head bolt
Screwing in the T-head bolt
3. Screw in the wing nuts 90° clockwise until they reach
the stop.
Fig. 7: Screwing in the T-head bolt
4
Figu-
Figure 2, p. 2.
SolvisFera / SolvisLuna LU-23x Technische Änderungen vorbehalten 03.17 BAL-GR-F/LU-M SOLVIS
Tightening the collector grip
4. Use the star-shaped knob to tighten all sides.
When doing so, be sure that the wing nuts remain
in a vertical position.
Fig. 8: Tightening the collector grip