Remote Control - AVer DL30 Schnellanleitung

Remote Control

The remote control requires two "AAA" size batteries. Make sure batteries are installed properly
before use.
(9) Reset
(10) ▲,▼,◄, & ►
(11) Enter
(12) Zoom In/Out
(13) EV +/-
Name
(1) Power
(2) Remote Control LED
(3) Menu
(4) Switch
(5) Auto Tracking On
(6) Auto Tracking Off
(7) Number buttons
(8) Preset
User can use below two ways to cancel pre-configured preset position:
a) press "Reset" + "Number button (0~9)" simultaneously, or
b) hold "Reset" then press "Number button (0~9)".
Remote control LED and camera button LED will not light when pressing
Reset button alone.
Pan and tilt the camera. Pan/Tilt speed by remote control is fixed. You
may change pan/tilt speed by using web browser. For setting details of
web browser, please refer to user manual.
After opening the OSD menu, confirm the selection or make a selection
in OSD menu.
Zoom in/out. Zoom in/out speed by remote control is fixed. You may
change zoom in/out speed by using web browser. For setting details of
web browser, please refer to user manual.
EV level adjustment.
English-4
Function
Turn the unit on/standby/privacy:
 Press once to turn on privacy
mode. Press again to turn off
privacy mode.
 Long press for 3 seconds to turn on
standby mode. Short press again to
turn off standby mode.
It will be on when pressing other
buttons.
Open and exit the OSD menu.
[Note] DL30 does not support OSD
menu.
Switch from presenter to another
presenter.
Turn on auto tracking.
Turn off auto tracking.
Use for setting the preset position 0~9.
User can use below two ways to set the
preset position:
a) press "Preset" + "Number button
(0~9)" simultaneously, or
b) hold "Preset" then press "Number
button (0~9)".
Remote control LED and camera button
LED will not light when pressing
Preset button alone.