VXi BlueParrott B350-XTS Kurzanleitung

IMPORTANT: CHARGE HEADSET FULLY PRIOR TO FIRST USE
All manuals and user guides at all-guides.com
VXi BlueParrott
Quick-Start Guide
Package Contents
1. B250-XTS™ Headset
2. Spare Foam Ear Cushion
3. Spare Microphone Windscreen
4. USB Charging Cable
5. Quick-Start Guide
6. Warranty and Compliance Insert
Features and Functions
A. Multifunction Button (MFB)
B. Indicator Lights
A
C. Volume Up/Mute
B
D. Volume Down
E. Flexible Microphone Boom
C
("Talk" side towards mouth)
D
IMPORTANT SAFETY NOTE: Prolonged exposure to high volume levels can damage your hearing. To avoid injury, set the
volume to the lowest comfortable level. If you experience ringing in your ears, or voices sound muffled, stop using the
headset. Avoid turning up the volume to block noisy surroundings. Your ears may adapt to volume that is too high, which
could result in permanent hearing damage without any noticeable discomfort.
Wearing and Adjusting the B250-XTS
For best noise-canceling performance, position the microphone towards the corner of your mouth. Positioning is
important; small adjustments in microphone placement can improve performance.
1. Place the headset on your head.
2. Position the speaker directly over your ear by sliding the headband in or out of the side support.
3. Align the "Talk" side of the microphone toward your face.
4. Position the microphone at the corner of your mouth—about one finger's width away from your face.
5. To adjust the headband tension, flex it outward to loosen or inward to tighten.
Charging
Connect the USB charging cord to the headset. The headset LED will glow red when charging and blue when fully
charged.
Power B250-XTS On/Off
On: Hold down the MFB for 2-3 seconds, until you hear a voice prompt (in English), "Power On." The blue light
will quickly flash three times as the headset turns on.
Off: Hold down the MFB for 3-4 seconds, until you hear a voice prompt (in English), "Power Off." A red light will
flash 4 times and the headset will turn off.
Manual Pairing
Placing Headset into Pairing Mode: With the headset powered off, press and hold the MFB. You will hear
the voice prompt "Power On" (in English). Keep holding the MFB for approximately 10 seconds, until you hear
"Discovering" (in English). Indicator lights will alternately flash between red and blue. Headset will be visible for
pairing to devices for 120 seconds.
Pairing to a Cell Phone:
1. Make sure that other Bluetooth devices are turned off or out of range.
2. Place headset into pairing mode.
3. Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer's instructions.
4. Select "VXi B250-XTS" to pair. (Passcode is "0000" if needed.)
5. When connected, the headset will give you the voice prompt, "Your headset is connected" (in English).
Multi-Point Mode
In multi-point mode, the headset can be simultaneously paired and connected to two cell phones. The headset
will allow you to switch between phones when there is an incoming call. Multipoint needs to be enabled on the
headset to do this. See the full user guide for more information.
Quick-Reference Tables
Function Button/Duration of Press LED Indicator
Power On MFB (2-3 seconds) 3 fast blue flashes
Power Off
MFB (3-4 seconds) 4 fast red flashes
Enable Pairing Mode
MFB (5-15 seconds) Alternating red and blue flash
Volume Up Volume Up (quick press) NONE
Volume Down Volume Down (quick press) NONE
Mute (On/Off) Volume Up (2 seconds) NONE
Answer a Call/Active Call MFB (quick press) Blue flash, once per second
End a Call MFB (quick press) Blue flash, every 4 seconds
Transfer Audio Volume Down (1-2 seconds) NONE
Low Battery
n/a Red flash
Multiple Device Pairing and Advanced Features
The VXi BlueParrott B250-XTS can pair with up to eight (8) devices. However, only two (2) devices may be
connected to the headset at one time (Multi-Point). For more information on advanced features, please refer to
the complete user guide, available online.
For the full user guide, technical notes, and available accessories, go to vxicorp.com.
271 Locust Street | Dover, NH 03820
Phone: +1 603 742-2888 | vxicorp.com
© 2015 VXi Corporation. All rights reserved. APN 203895A 12/15
B250-XTS
® ™
E
Audio Indicator Voice Indicator
Short tone "Power on"
NONE "Power off"
NONE "Discovering"
Single tone NONE
Single tone NONE
Single tone, reminder NONE
tone every 10 seconds
Two rising tones NONE
Two falling tones NONE
Long, low tone NONE
NONE "Battery low"