Beamz STARCOLOR 72 Benutzerhandbuch Seite 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product
must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and
may be used. No dimmer or adjustable power supply.
The unit has a powerconnector output on board. Depending on the local conditions several units can be linked by powerconnector in- and output.
Connect a maximum of four (when using 230V/16A) units in a row. Use an approved three-core cable with a cross-section of at least 1.5 mm². The
installation instructions of the manufacturer and the colour coding of the cable must be observed. Do not turn off the unit by turning the
powerconnector but use the power on/off switch or schuko!
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
In temporary installations, you can suspend the fixture from a rigging truss by means of a rigging clamp that is approved for the weight of the
fixture securely fastened through the hole in the center of the bracket (A). The fixture must be installed hanging vertically downwards only. When
using a rigging clamp, secure the fixture with a safety cable, that is approved for the weight of the fixture so that the safety cable will hold the
fixture if the rigging clamp fails. Remove as much slack as possible from the safety cable (by looping it more than once around the truss chord, for
example). Check that the truss and all fasteners used can support 10 times the weight of all the fixtures and equipment that they will support.
When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let
the installation checked out by an authorized dealer!
To anchor the mounting bracket to a wall or other flat surface, use three high-strength corrosion-resistant fasteners that are safe for the
application. Use selflocking nuts! Install washers under all nuts and bolt heads. Make sure that there is a washer between each fastener and the
bracket. Ensure that the surface and all fasteners used can support 10 times the weight of all the fixtures and equipment that they will support.
Fasten the center of the bracket with a 10 mm (25/64inch) shaft diameter bolt in the center hole A. Then use two bolts with 8 mm (5/16 inch) shaft
diameter passing through the curved slots B to anchor the fixture. This setup will give approximately 90° of pan adjustment.