Cleaning; Changing The Attachments; Replace Filters; Inlet Filter - MEDIX AC2000 Bedienungsanleitung

6.3 Cleaning

In order that you benefit fully from your equipment, it is important that the machine and accessories are kept in a clean
condition. Ensure that the medication chamber is taken apart and washed in warm soapy water. Rinse and allow to dry
after each use. The jet holes should be blown clear by attaching the chamber to the air outlet from the compressor and
running the machine for a couple of minutes.
We advise that the tube is disconnected from both the outlet filter and the chamber after each use to prolong the life of
the connector.
The compressor nebuliser devices are suitable for cleaning daily with approved CE marked disinfectant wipes for the
lifetime of the device.
WARNING: Accessories are not for multiple patient use due to risk of infection.
Device must be cleaned between patients to prevent risk of infection.

6.4 Changing the Attachments

It is recommended that the following disposable items should be changed as follows:
Medication chamber

Inlet filter

Driveline
Face Mask
Mouthpiece
Outlet filter
Only medication chambers supplied or approved by Clement Clarke International should be used.

6.5 Replace filters

AC2000 - only replace inlet filter
Inlet filter:
Using the filter spanner, unscrew your used, white, inlet filter in an anti-clockwise
direction and discard.
Replace with a new filter, ensuring you have the white inlet filter.
Screw the white inlet filter, into the left-hand hole on the front panel, in a clockwise
direction, tightening with the filter spanner.
Outlet filter for the Econoneb/Turboneb 2:
Using the filter spanner, unscrew your used, blue, outlet filter in an anti-clockwise
direction and discard.
Replace with a new filter, ensuring you have the blue outlet filter.
Screw the blue outlet filter, into the right-hand hole on the front panel, in a clockwise
direction, tightening with the filter spanner.
}
change every 3 months
}
change every 12 months
en
5