Multi Step Programming; Steps; Notes - Dieta MI-MX Betriebsanleitung

MULTI STEP PROGRAMMING

Multi step programming is almost like QUICK
programming, except:
• program starts when you press START
• program steps can be seen by pushing the
STEP button on the upper right hand corner of
the main display
• you can add notes (yellow stickers) to the steps
• only measure liters is available (no open/close
valve)

STEPS

Step being programmed can be seen in the main
display upper right hand corner. Push this button
to go to the next step. If you make no settings,
the next push brings you to step 1. The step may
contain just a break: set time, but nothing else.
Program may contain up to 6 steps

NOTES

Note will be shown at the beginning of the step.
Opening and closing the lid will remove the note
from the screen.
If you want to add or delete a note, push NOTE
button.
You can select the note from the list. The list may
be scrolled up and down. Select a note by pushing
it - it will be moved to the center over the blue
ribbon. Press the ribbon to accept.
Push NO NOTE to remove the note (or to return back
without setting a note).
If you want a new note, press NEW NOTE – and
you can write a small note yourself. This note text
is added as last note to the list. Note that the
list shows only the beginning of the note on the
display.
DIETA MI-MX user manual 5/2019 • Page EN-26