Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation:
This product may only be installed by a qualified electrician.
The connection lines in the building must be switched free of voltage before installation.
Remove the corresponding safety circuit breakers from the building installation to do this.
The light is suitable for installation into normal combustible surface. Under no circumstances
whatsoever must the light be covered with heat insulating coverings or similar materials.
The use of an earth leakage circuit breaker for protection is recommended when the wall light
is used outdoors.
Make sure that no water can collect at the place where the light is fastened.
Make sure that you have a suitable base and that the weight of the light can be supported
permanently and reliably.
You can install the LED light with the built-in housing in surfaces such as concrete, or other
materials, or it can be built into wooden panels or other materials without the built in housing
(see the sketch below).
Avoid direct contact with the conductor panels during the assembly and installation work.
Feed the supply lines for the power supply through the openings in the built-in housing.
Connect up the connection lines of the building installation to the screw terminals of the light.
Connect up the green-yellow ground wire first of all and then both the other lines. The brown
(or black) cable is usually the phase conductor. Connect this to the terminal marked with an
"L". The blue conductor must be connected to the terminal marked with an "N".
Do not bend the cable, please make sure that the cable and plug are free from tensional and
rotational forces. Protect all the cables and insulations from possible damage.
Make sure you have a stable and reliable fastening.
Switch on the safety circuit breakers again.
The name plate must not be removed.
Installation instructions Art. No.36668
Glass liner
Lamp housing
Lampengehäuse
Clips
Page 2 of 2
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Status 08.2011
Werbung
