Kripsol STARCUS ONE W Bedienungsanleitung Seite 5

IMPORTANT! 1- CHANNEL TRANSMITTER
1. The function of the programming button is performed by the combination of UP + STOP keys pressed simultaneously.
2. The batteries must be replaced when the integrated LED does not light up, or when the receiver
stops responding at the moment of pressing the keys.
IMPORTANT! 15-CHANNEL TRANSMITTER
1. The programming function is performed by the combination of ZERO and CHANNEL + buttons pressed
simultaneously.
2. After pressing the ZERO button, the digit 0 indicating the group channel appears on the display.
All devices programmed on individual transmitter channels are active on this channel.
We do not perform any programming procedures on the group channel.
3. The batteries must be replaced when the channel number is not displayed after pressing any button,
or when the receiver stops responding at the moment of pressing the keys.
3. PROGRAMMING THE FIRST TRANSMITTER FOR ER TYPE DRIVES
1. The programming of the transmitter depends on the type of receiver. When programming, it is necessary
to be guided by the instruction manual of the device which is to be controlled by the transmitter.
2. A pause longer than 5 seconds between successive presses of the button will automatically cause
exit from the programming mode without any introduced changes.
3. Adding a transmitter using this method will cause erasing the memory of the receiver.
LUB
We turn on the The drive will
power supply emit a sound.
or press the The roller blind
programming will make short
button on the up / down
drive head. movements.
4. SELECTION OF ACTIVE CHANNELS
Pressing the UP or DOWN button causes exit from the active channel selection mode. To change
the number of active channels again, it is necessary to perform the following procedure again.
We press and hold CHANNEL + and CHANNEL
-simultaneously. The „C" symbol will appear
on the display, and after about 4 seconds
the number 15 and the up and down arrows.
We simultaneo- The drive will
usly press the emit a sound.
STOP and UP
buttons or ZERO
and CHANNEL +
buttons on the
remote control.
Using the CHANNEL + or CHANNEL- buttons
we set the number of channels displayed.
We simultaneo- The drive will
usly press the emit a sound.
STOP and UP
buttons or ZERO
and CHANNEL +
buttons on the
remote control.
We press the UP The roller blind
button once. will make short
up / down
movements and
emit several
sound signals.
Using the STOP button, we confirm
the setting. The „o" symbol
is visible on the display.