Instructions; Installation Accessories; Installation - AEG KRC 4330 DVB-T Bedienungsanleitung

Installation Instructions
for Bottom-Mounted Devices
CAUTION:
Make sure that the plug is not inserted when
assemb ling the device.
• Remove all objects from the cupboard and
anything which is fragile in the adjacent cup-
boards.
• For the installation the cupboard must fulfil the
following conditions:
Thickness of the cupboard floor between
16 mm and 20 mm.
• The wall mounting of the cupboard must be stable
and anchored firmly in the wall with at least 2
screws.
• Important! Do not install the device above a
cooker!
• When installing the device it must be ensured that
there is a power socket within reach.
• The mains socket must be within easy reach,
so that the plug can be quickly removed in an
emergency.
• Important! Do not connect the device to the
mains power supply until after installation!
• The device cannot be installed under cupboards
under which there is a lighting strip.
• For installation you may require the following
items: a drill with 6 mm drill bit, gimlet or nail,
screwdriver, measuring tape, adhesive tape,
scissors, safety goggles.

Installation Accessories

4 screws
4 spacers
1 drilling template
CAUTION:
You should use only the installation accessories
supplied.
WARNING:
If screws are inserted too deeply (screws too
long) this may damage the device or represent a
hazard to the user or others.

Installation

Illustration A (see Page 4)
• Use the adhesive tape to adhere the template into
the cabinet with the word FRONT facing forward.
NOTE:
For cabinets with overhangs, first insert the
crosses into the attachment points. Then stick the
drilling template, with the printed side up, under
the cabinet.
• Adhere the template firmly under the cupboard
with adhesive tape. With the help of a gimlet or
nail pierce the crosses at the attachment points
and use it to mark the holes.
• Remove the template and drill the holes into the
wall cupboard.
Illustration B (see Page 4)
Lightly turning the spacer gives you a choice of
three different heights.
• Choose the spacer position that best matches
the moulding. Insert the spacer into the holes
provided on the device.
CAUTION:
The thickness of the cupboard floor must be
between 16 mm and 20 mm.
NOTE:
Sufficient ventilation is only guaranteed with a
spacer.
Illustration C (see Page 4)
• Countersink the screws into the holes in the
cupboard.
• Using the 4 screws and the spacers, attach the
kitchen radio to the bottom of the cupboard.
• Tighten the screws with a screwdriver until they
are hand tight.
CAUTION:
You should use a hand screwdriver and not a
battery-driven one.
English
23