Braun ProSkin 3 Serie Bedienungsanleitung Seite 15

Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has
to be fully discharged by shaving every 6 months approximately. Then recharge the
shaver to full capacity.
Clean&Charge Station (C)
The Clean&Charge Station has been developed for cleaning, charging, lubricating,
drying and storing your Braun shaver.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using the Clean&Charge Station
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
• After having pressed the lift button to open the housing, wait for a few seconds before
removing the used cartridge.
• Before discarding the used cartridge, make sure to close the openings using the lid of
the new cartridge, since the used cartridge will contain contaminated cleaning solution.
• The used cartridge can be disposed of in the household waste.
Operating your Clean&Charge Station
• Connect your Clean&Charge Station with the cord set to the mains electricity supply.
The special socket at the back is adjustable to save space. After each shave, switch
the shaver off and put it into the Clean&Charge Station, upside down and with the
front showing. Important: The shaver needs to be dry and free from any foam or
soap residue!
• Push the start/release button (1) to lock and connect the shaver. The cleaning process
will start. The yellow light on the shaver will flash during the complete process (approx.
2 minutes cleaning, min. 4 hours drying).
• Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press the start/release button (1).
• When cleaning is finished, the yellow light will go off. To release the shaver, push the
start/release button.
• A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level
indicator (4) has reached the « » mark, the remaining fluid in the cartridge is sufficient
15