Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
MPS-CO2 Operating Manual
1. Features
The MPS-CO2 Remote Sensor is a range of gas detectors to be used with monitoring units SPxx or
MPUx.
2. Models
Model
MPS-CO2-2000 (option)
MPS-CO2-5000 (option)
MPS-CO2-10000 (standard)
MPS-CO2-30000 (standard)
3. Function
The sensor continuously measures the gas concentration and gives an analog signal to the monitoring
unit, when the signal reaches the alarm thresholds an alarm will be activated.
Alarm levels are always set in the monitoring unit.
4. Installation/Positioning
The general rule is that the detector should be placed as close to the potential leak as possible, and at
the same time consider the gas density and any air movements in the room. The detector must also
be positioned in such a way that it is easily accessible for service. See Fig. 1 for suggestions on
suitable placement. Installation is carried out according to the Fig. 4.
5. Function Control
Testing the system is recommended to be done once a year using a service tool. Connect service tool
to the test terminal 1 (Fig. 4).
6. Technical Data
Housing CO
:
2
Sensor cable (up to 50 meters):
Sensor cable (up to 100 meters):
Temperature:
Humidity:
This product is intended for use in the industrial area.
Specifications subject to change
5/12
MPS-CO2
Used for
Carbon Dioxide (CO
) 0-2000 ppm
2
Carbon Dioxide (CO
) 0-5000 ppm
2
Carbon Dioxide (CO
) 0-10000 ppm
2
Carbon Dioxide (CO
) 0-30000 ppm
2
Grey polycarbonate (PC) IP67
3 x 0,75 mm
2
3 x 1,5 mm
2
-40 °C..+50 °C
0-95% RH (non-condensing)
IS MPS 200930
Werbung
