Setting The Current Time - Kripsol STARCUS SCENARIO Bedienungsanleitung

5. SETTING THE CURRENT TIME

1. Time setting must only be carried out in manual mode.
2. A pause longer than 60 seconds between successive button presses will automatically cause exit
from the programming mode without any introduced changes.
We press the We press and hold
OPERATION MODE the TIME CHANGE
button to set the
manual operation
mode. The current time
setting flashes on
6. AUTOMATIC TIME SETTING FOR LIFTING AND LOWERING
1. Changes to lifting and lowering times are only made in automatic mode.
2. The time of automatic lifting and lowering must be set separately on each channel.
3. A break longer than 60 seconds between successive presses of the button will automatically cause
exit from the change mode.
4. The group channel must be turned on so that the transmitter will control all blinds. It relates to all
transmitter operation modes.
5. In the course of setting the time of automatic lifting and lowering, the symbol "- -: - - „means that
the given time is not active in the automatic mode.
6. The difference between the programmed time of automatic lifting and lowering cannot be less than
32 minutes. In case of trying to set the time with a difference less than the admissible, the display
will show an error message and the introduced changes will not be saved.
7. In order to exit the time change mode without saving the changes it is necessary to press the STOP button.
8. The time of automatic opening and closing is set separately for each day of the week.
We press the OPERATION
MODE button to set the
automatic operation mode.
We set the appropriate va-
lue using the UP or DOWN
buttons.
We press the P1 +
button to select the
button for 3 option of changing
seconds hours, minutes or
days of the week.
the display.
We press and hold the
TIME CHANGE button for 3
seconds. The lifting time is
visible on the display
Using the OPERATION
MODE button, we go
through between the hour
of lifting and lowering
We set the ap-
propriate value using
the UP or DOWN
buttons.
Using the UP or DOWN We press the TIME CHAN-
buttons we can check the GE button. The lifting time
set time on each day of
the week.
Using the TIME CHANGE button
we change the day of the week on
which the time of automatic lifting
and lowering is programmed.
By pressing and
holding the TIME
CHANGE button
for 3 seconds we
confirm the changes
introduced (the hour
will stop flashing).
We press the P1 + button
flashes on the display.
After setting the automatic lifting and
lowering times on each day of the week,
we confirm the settings
by holding the TIME CHANGE
button for 3 seconds
We press the TIME
CHANGE button to
start the clock.
to select the option
of changing hours
or minutes.