Vapojet System; Using The Vapojet - Elnapress 250S Bedienungsanleitung

VAPOJET SYSTEM

Elnapress is equipped with an exclusive Vapojet system for the formation of
natural steam.
The Vapojetet allows to spray simple tap water directly on the items to be
ironed. The natural vaporization combined with the automatic pressure and
the heating shoe heat regenerate the fibers of the fabric in depth.
The (force of) natural vaporization is obtained by combining the vaporization
of the Vapojet, with the forces exerted by the Elnapress ironing board, the
automatic pressure and the heat of the heating shoe.
This combination of forces and elements are formed directly inside your
garments and in addition to obtaining an impeccable ironing quality without
any effort, it is able to regenerate the fibers of the fabric in depth enhancing
the colors and safeguarding them from aging.
The Vapojet operates without any electricity consumption.
N.B. Do not put starch in the water.
18

USING THE VAPOJET

To remove the Vapojet, simply slide it out of the fixed handle.
1) Remove the cap and fill it with about ¾ of water.
Do not completely fill the Vapojet.
2) Replace the cap and slide the Vapojet onto the fixed handle. Press the lever
first slowly, then faster until nebulization. Now it's ready to use.
If at first use after following step 2 your Vapojet does not nebulize we
recommend:
1. Carefully check that the cap closure is correct. In case open and close again.
2. Position the Vapojet vertically, directly under the sink tap and with the cap
facing upwards.
Open the cap and start the water filling procedure. While filling and remaining
in a vertical position, press the Vapojet lever repeatedly until nebulization.
When in operation, close the cap and hook the Vapojet to your press.
3) Place the garments on the board, spray the Vapojet lever several times and
lower the heating shoe to create natural steam.
N.B: you can perform the spraying operation even while you are lowering the
heating shoe.
1)
2)
3)
19