RADEMACHER DuoFern 9475 Einbau- Und Bedienungsanleitung Seite 35

i
Installation of the DuoFern Environmental Sensor
Preparation of the DuoFern Environmental Sensor
1) Cover with rain
sensor
2) Cover
latch
3) Printed circuit
board
4) Lower section
of housing
Unlock the cover and lift
off from above
The cover of the DuoFern Environmental Sensor with the rain sensor is latched at
the lower edge on the left and right (see Fig.). Remove the cover from the DuoFern
Environmental Sensor. Proceed carefully to avoid tearing off the cable connection
between the printed circuit board in the lower section and the rain sensor in the cover.
EN
1)
2)
3)
4)
35