AAVA MOBILE Inari 8 Kurzanleitung Seite 8

is designed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the
closer you are to a wireless base station antenna, the lower the power output.
While there may be differences between the SAR levels of various devices and at various positions, the all meet the
government requirement.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be
found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on the below:
FCC ID: 2ABVH-INARI8B1
This device is compliant with SAR for general population / uncontrolled exposure limits in SNAI / IEEE C95.1-1999 and had
been tested in accordance with the measurement methods and procedures specified in the Office of Engineering and
Technology (OET) Laboratory Division Knowledge Database (KDB), 447498 D03.
Specific Absorption Rate (SAR): 1.19 W/kg
This product has been tested and found to comply with the following standards:
•
For the worst case positions, the INARI8 is in compliance with the IC RSS 102 Issue 5 (RSS 102) and Federal
Communications Commission (FCC) Guidelines (KDB) 447498 D03 for uncontrolled exposure.
SAR assessment in body worn was conducted with a distance of 0 mm between the housing of the handheld
and the flat phantom.
•
EM 62311:2008: Assessment of electronic and electrical equipment related to human exposure restrictions
for electromagnetic fields (0 Hz – 300 GHz).
Radio Frequency Interference Requirements - Canada
CAN ICES-3 (B)/NMB-3(B)
Radio Transmitters
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1)
This device may not cause interference; and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radio électrique subi même si le brouillage est susceptible d'en
compromettre le fonctionnement.
For RLAN Devices:
The use of 5 GHz RLAN's, for use in Canada, have the following restrictions:
• Restricted Band 5.60 - 5.65 GHz
Pour les équipements RLAN:
L'utilisation de la bande RLAN 5 GHz au Canada présente les limitations suivantes :
• Bande restreinte 5.60 - 5.65 GHz
Label Marking: The Term 'IC:' before the radio certification only signifies that Industry Canada technical
specifications were met.
Etiquette de marquage: Le terme "IC" avant la certification radio signifie que le produit est compatible
avec le spécification Industrie Canada.
IC type approval ID: 11875A-INARI8B1
Radiation Exposure Statement (SAR)
Warning: This equipment complies with SAR for general population / uncontrolled exposure limits in SNAI / IEEE C.951,
Federal Communication Commission Office of Engineering and Technology (KDB) 447498 D03, Canada RSS-102, and
CENELEC limits for exposure to radio frequency (RF) radiation.
Specific Absorption Rate (SAR) 1.19 W/kg
Énoncé sur l'exposition aux radiations (SAR)
Avertissement : Cet équipement est conforme aux limites d'exposition au rayonnement à fréquence radioélectrique (RF)
établies par la Commission internationale de protection contre les rayonnements non ionisants (ICNIRP), le Federal
Communications Commission Office of Engineering and Technology (KDB), 447498 D03, la norme CNR-102 d'Industrie
Canada et le règlement CENELEC.
Débit d'absorption spécifique (DAS) : 1.19 W/kg
Inari 8 (INARI8B) – Quick-Start-Guide – EN-DE-FR
7