Strong HELO CAMERA-B-ADDON Schnellstartanleitung Seite 6

EN
IV. Adding Device
1. Please press the On/O button of all cameras one by one. Then
the cameras will beep, and the indicator light of the camera will start
to fl ash red; If the indicator light does not fl ash red, please press and
hold the reset button for 5 s to reset the camera.
2. Enter the Base station interface on the Helo by Strong app, click
the "+Add Device" in bottom, or press the pairing
button on top of the base station to enter pairing
status, the Indicator light 2 will fl ash green.
3. When the camera successfully pairs to base station, a voice
prompt will be heard from camera and camera's indicator light will
turn green, while Indicator light 2 of base station will turn o and
base station will exit the pairing status. Then the added cameras will
be displayed on the app.
4. If there is any camera that could not pair to the base station,
please add the camera again following the above 1
V. Charging Camera
1. The camera is with built-in 6000 mAh rechargeable battery.
2. When charging, please use the camera USB cable to connect
camera and camera adaptor, then plug the adptor into a power outlet
(100 V -240 V) for charging. The indicator light on camera will turn
solid white indicating that the device is in charging (if the indicator
light fl ashes when charging, please contact customer service).
3. It requires 4 hrs for full charging. Once full charged, the white
indicator will turn o
Helo by Strong
2 3 steps.